Howard Barrow

Mastering and lacquer cutting engineer from the UK.
Worked as cutting engineer at Estudios Hispavox.
His cuts from the Pye Studios era can be identified as follows:
△H (cut on the Westrex/Scully stereo lathe until 1967, then on the Neumann VMS-60/SX68 lathe).
◊H (cut on the Westrex/Scully stereo lathe until 1974, then on the Neumann VMS-70/SX74 lathe).
✳H (cut on the Westrex/Scully mono lathe until ca. 1974).
In these cases, please use
Lacquer Cut At - Pye Studios
Lacquer Cut By - Howard Barrow + ANV H (without symbols).